Preparation & Measurement Guide

BPC-157 10mg Dosage Protocol

Preparation, measurement, commonly documented protocol ranges, and storage for a BPC-157 10mg vial.

Research use only Educational summary of a commonly published convention. Not approved for human use.
Vial Size 10mg BPC-157
Preparation 2mL bacteriostatic water
Concentration 5mg/mL after preparation
Published Convention 200-600mcg once daily

1. Preparation and Measurement

10mg Vial With 2mL of Diluent

Add 2mL of bacteriostatic water to the 10mg vial. The resulting concentration is 5mg/mL. On a U-100 syringe, each unit contains 50mcg.

10mg / 2mL = 5mg/mL
1 U-100 unit = 0.01mL = 50mcg

Preparation

  1. Draw 2mL of bacteriostatic water using sterile equipment.
  2. Let the liquid run slowly down the inside wall of the vial.
  3. Gently swirl until dissolved. Do not shake.
  4. Label with the preparation date and refrigerate.

Check the calculation with the peptide calculator.

2. Commonly Documented Schedule

Route commonly described: subcutaneous. Frequency: once daily.

Period Documented daily amount Measurement
Weeks 1-2 200mcg once daily 0.04mL / 4 units
Weeks 3-4 400mcg once daily 0.08mL / 8 units
Weeks 5-8+ 600mcg once daily 0.12mL / 12 units

One 10mg vial lasts approximately: 50 days at 200mcg, 25 days at 400mcg, or 16 days at 600mcg.

Practical Notes

  • The table applies only to a 10mg vial prepared with exactly 2mL.
  • Four units is a small measurement; account for the accuracy of the measuring device.
  • Record the amount, date, and preparation used.

3. Supplies Needed

  • BPC-157 10mg vial.
  • 2mL of bacteriostatic water per vial.
  • Sterile U-100 syringes.
  • Alcohol swabs.
  • Sharps container.

4. Storage and Handling

  • Keep unopened vials cool, dry, dark, and protected from moisture.
  • After preparation, refrigerate at 2-8 degrees C.
  • Protect from light and avoid repeated freeze-thaw cycles.
  • Do not use material with particles, discoloration, or a damaged seal.

5. Research Context

BPC-157 has been examined mainly in animal and cell studies involving tendon response, fibroblasts, angiogenic signaling, wound models, and gastrointestinal injury. These findings do not establish human efficacy or a clinically validated dose.

BPC-157 is not an approved therapeutic drug. FDA materials note limited human safety information and potential concerns involving immunogenicity, peptide-related impurities, and ingredient characterization.

Primary Research and Regulatory References

  1. Transected rat Achilles tendon and tendocyte study, Journal of Orthopaedic Research (2003)
  2. Rat Achilles tendon-to-bone healing study, Journal of Orthopaedic Research (2006)
  3. Tendon-fibroblast growth-hormone-receptor study, Molecules (2014)
  4. Wound, endothelial migration, and angiogenesis study (2015)
  5. VEGFR2 activation and angiogenesis study (2017)
  6. FDA: BPC-157 compounding and safety concerns

Research Materials

Review BPC-157 Product Information

← Back to Dosage Protocols

Research-use disclaimer: BPC-157 products sold by Vialcrest are intended strictly for laboratory research. They are not intended for human consumption, injection, therapeutic use, medical use, diagnostic use, or veterinary use. This article documents how a commonly circulated non-clinical protocol is described for educational comparison. It does not endorse that protocol, establish safety or efficacy, or provide medical advice.