Melanotan-2 10mg Dosage Protocol

1. Preparation and Measurement

Melanotan-2 10mg With 2mL of Diluent

Add 2mL of bacteriostatic water to the vial. The resulting concentration is 5mg/mL. On a U-100 syringe, each unit contains 50mcg.

Preparation

1. Draw 2mL of bacteriostatic water using sterile equipment.
2. Let the liquid run slowly down the inside wall of the vial.
3. Gently swirl until dissolved. Do not shake.
4. Label with the preparation date and refrigerate.

Check the calculation with the peptide calculator.

2. Commonly Documented Schedule

Route commonly described: subcutaneous in circulated protocols. Frequency: once daily.

Vial estimate: One 10mg vial contains approximately 40 administrations at the first listed amount or 13 at the final listed amount.

Practical Notes

• The table applies only to this vial prepared with exactly 2mL.
• Record the amount, date, and preparation used.

3. Supplies Needed

• Melanotan-2 10mg vial.
• 2mL of bacteriostatic water per vial.
• Sterile U-100 syringes.
• Alcohol swabs.
• Sharps container.

4. Storage and Handling

• Keep unopened vials cool, dry, dark, and protected from moisture.
• After preparation, refrigerate at 2-8 degrees C.
• Protect from light and avoid repeated freeze-thaw cycles.
• Do not use material with particles, discoloration, or a damaged seal.

5. Research Context

Melanotan-II is an unapproved melanocortin analogue studied in early human experiments. Published case reports also describe clinically significant adverse effects associated with unregulated use.

No approved dosing standard exists for Melanotan-II. The table documents a circulated convention and does not establish safety.

Primary Research and Regulatory References

1. Melanotan-II early human study
2. Melanotan-II human response study
3. Melanotan-II safety case report