TB-500 5mg Dosage Protocol

1. Preparation and Measurement

TB-500 5mg With 1mL of Diluent

Add 1mL of bacteriostatic water to the vial. The resulting concentration is 5mg/mL. On a U-100 syringe, each unit contains 50mcg.

Preparation

1. Draw 1mL of bacteriostatic water using sterile equipment.
2. Let the liquid run slowly down the inside wall of the vial.
3. Gently swirl until dissolved. Do not shake.
4. Label with the preparation date and refrigerate.

Check the calculation with the peptide calculator.

2. Commonly Documented Schedule

Route commonly described: subcutaneous in circulated protocols. Frequency: once daily.

Vial estimate: One 5mg vial contains approximately 10 administrations at the first listed amount or 5 at the final listed amount.

Practical Notes

• The table applies only to this vial prepared with exactly 1mL.
• Record the amount, date, and preparation used.

3. Supplies Needed

• TB-500 5mg vial.
• 1mL of bacteriostatic water per vial.
• Sterile U-100 syringes.
• Alcohol swabs.
• Sharps container.

4. Storage and Handling

• Keep unopened vials cool, dry, dark, and protected from moisture.
• After preparation, refrigerate at 2-8 degrees C.
• Protect from light and avoid repeated freeze-thaw cycles.
• Do not use material with particles, discoloration, or a damaged seal.

5. Research Context

TB-500 is associated with thymosin beta-4 research involving cell migration, wound models, and tissue repair. Commercial TB-500 material should not be assumed identical to full-length thymosin beta-4 used in published studies.

TB-500 is not an approved therapeutic drug. No clinically validated dosing schedule has been established.

Primary Research and Regulatory References

1. Thymosin beta-4 wound-healing research
2. Thymosin beta-4 cell-migration study
3. Thymosin beta-4 repair research review